How To Repair The Broken Edge Of An Oak Cabinet Drawer
Introduction
I have a cleaved cabinet door that was accidentally, snapped into ii sections. I plan to utilize a ii office 5 minute epoxy, with wood bonding compatibility and duct tape to assist hold the 2 sections together while the epoxy cures. With this simple process I will have a fully repaired cabinet door in under xxx minutes.
Tools
Parts
No parts specified.
-
-
This is the broken dresser drawer, duct tape & 5 minute ii part wood epoxy.
-
-
-
Take a piece of duct tape and put it on both sides for actress bonding support. Only put the record on the bigger part of the dresser door for now. You will adhere the other side with tape in a afterward step.
-
-
-
This is a v minute quick setting 2 part wood epoxy. Take the tiptop off the epoxy. Connect the syringe tip and lock it in place. Press the plunger then yous tin can fill up the needle tip with epoxy.
-
-
-
Run a thick bead of epoxy on the inside rim of the cabinet from one finish to the other.
-
-
-
Run a thick bead of epoxy on the inside rim of the smaller piece of cabinet door.
-
-
-
Attach and marshal the smaller cabinet door section to the bigger cabinet door department. Press them firmly together and apply the duct tape on both ends for bonding back up.
-
-
-
Flip door over to front end side and tape both ends of the chiffonier. This volition add more support while it is drying.
-
-
-
Later on at least xv minutes you tin can pull tape off completely and wipe abroad whatsoever excess epoxy. It is at present finished and set to be re-installed back to the cabinet.
-
Almost done!
To reassemble your device, follow these instructions in contrary order.
Determination
To reassemble your device, follow these instructions in reverse order.
Squad
0 Comments
Source: https://www.ifixit.com/Guide/How+to+Repair+a+Broken+Cabinet/58518
Posted by: andrewsmuffe1948.blogspot.com
0 Response to "How To Repair The Broken Edge Of An Oak Cabinet Drawer"
Post a Comment